Standing seam and metal panel roofing, roof repair and full replacement in Glencoe. We show up when we say we will, and we clean up before we go.
Metal roofing is our specialty, but shingles, gutters, soffit and leak work all get the same attention in Glencoe.
Old skylights leak at the flashing long before the glass ever fails. We reflash, reseal, or set a new unit and tie it in properly.
Squirrels, wasps and water all treat a soft soffit as a front door. We close it up properly instead of patching over it.
Hard wind lifts shingles and works panel fasteners loose along the edges, which is exactly where the next storm gets underneath. We refasten, replace and reseal.
From a few tabs to a whole slope, we fix shingle roofs without pushing you toward a replacement you are not ready for.
Reflective coatings keep a metal roof cooler in summer and seal up the small stuff before it turns into a leak.
Storm damage does not wait for business hours. We get the opening closed, photograph it for your insurance, and put the real fix on the schedule.
Careful footwork, matched materials, and flashing done the way it was done when the roof went on.
Ice backs up at a cold eave and pushes water sideways under the roof. We clear it without gouging the panels or the shingles.
Waterproofing details on additions, porches and low slope tie ins, where two roofs meet and most leaks quietly begin.
We work around your hours, weekends included when that is what it takes to keep your doors open while the roof goes on.
Wind and debris damage is not always obvious from the ground. We check the edges, the ridge, the valleys and the fasteners before telling you anything is fine.
Porch roofs, additions and low slope sections that hold water instead of shedding it. We rework the flashing, seal the seams, and get water moving again.
Water runs along decking and rafters before it ever drips, so the stain is rarely under the hole. We trace the leak back to where it really starts and fix that.
Inspections come free with an estimate. We would rather find the small problem this spring than replace a ceiling for you next winter.
We repair standing seam, exposed fastener panels and metal shingles, and we match the color as closely as the paint system will allow.
When a roof is genuinely finished we replace it, and we say so plainly rather than dressing it up. Metal and shingle priced side by side so you can compare real numbers.
This is the work our name is attached to. Two decades of tin roofs on houses, churches, barns and additions, installed by crews who cut the trim on site instead of forcing something that almost fits.
Most roofs somebody has called a lost cause are not one. We repair what can be repaired, and we tell you honestly when a repair will no longer hold.
Guards and screens so you are not up a ladder every fall digging pine needles out of the gutter by hand.
Not every hailstorm ruins a roof. We look before we tell you anything, and if the damage is only cosmetic we will say that too.
Metal is what we are known for. Since 2002 the bulk of our work has been standing seam and metal panel roofs, and it is still what most Glencoe homeowners call us about. We measure on site, help you settle on a color, and set the panels straight.
We do shingle roofs too, and plenty of them. But if you have been thinking about a tin roof on your Glencoe home, that is the conversation we enjoy most — panel type, color, trim, and what it is really going to cost.
Here is what Glencoe homeowners tell us makes the difference.
The same family started this company putting metal roofs on neighbors houses in 2002. It has never been sold, franchised or handed off to a call center.
A few backed out screws or a whole roof off a church — we take both. No job is too small to get the same crew and the same care.
Around twenty standard metal colors, and the chart comes out with the estimate so you can hold it up against your siding and shutters before you commit.
Standing seam and metal panel roofs are the work we are known for. Color, trim, fastening pattern — we have done hundreds and we will walk you through all of it.
You get a start date and we hold to it. If weather moves your job we call you, rather than leaving you watching the driveway.
The questions that come up on just about every estimate we write.
Sometimes. If the decking is sound and there is only one layer of shingles, a Glencoe metal roof can go over the top on purlins. If there is rot underneath or two layers already on, we tear off first — and we will tell you that before you sign, not halfway through.
Most Glencoe metal roof jobs land somewhere between about $12,000 and $30,000 in 2026, depending on square footage, pitch, panel type and how much tear off there is. Standing seam runs higher than exposed fastener panels. We measure before we quote, and the estimate is free.
For most Glencoe homes, yes. A metal roof costs more up front than shingles, but it usually outlives two or three shingle roofs, sheds rain and snow better, and does not peel off in a hard wind. We will price metal and shingle side by side so you can compare real numbers instead of guessing.
Plenty of them. Most Glencoe customers choose from around twenty standard colors, and green, burgundy, bronze, black, gray, tan and barn red are the ones people pick most. We bring the color chart out with the estimate so you can hold it up against your siding.
No. Estimates are always free in Glencoe. We come out, measure, look in the attic if we can get to it, and leave you a written price. Nobody will push you to sign anything that day, and the number does not expire in an hour.
That is most of what leak work is. Water runs along decking and rafters before it ever drips, so the stain on your Glencoe ceiling is rarely under the actual hole. We work back to the real entry point, fix that, and check the rest of the roof while we are up there.
Real feedback from homeowners whose roofs we have worked on.
"Green metal over the whole house and the carport. Looks sharp, and it is quiet inside when it rains, which honestly surprised me."
"Thank you so much to the entire crew at Roofing Brothers for our amazing new tin roof! You were amazing to work with and I couldn't recommend you to others enough! Great communication, pricing, color options, efficiency, and HONESTY! If anyone needs a new roof, I highly recommend this crew! Phenomenal job."
"Standing seam on our log home. The panels are dead straight and the ridge work is clean. You can tell they have done a few of these."
Our crews cover the surrounding area, not only the city limits.